Today, installed the steering wheel. (makes it way-easer to steer).I installed the clutch cylinder . Started on the struts.
Also tested ride height? Looks like I can make it work with a 12" x 2 1/2" spring of 300# ? What do you think ? The gray is the stand-in spring. Its 2 1/2" Electric PVC. Also helps with the scaling of the chassis. When your as cheep as me. Trying to keep the spring I can't use down. LOL
Struts are Impreza AGX. Lots of mods to make them work.
For today I pulled the motor, rapped the exhaust (lost the top cover when I cut the pipe!) with temp cover and 3 layers of Alum. rap. Didn't want to melt the P/S hoses. Cut down the stand rear leg by 1 3/8". Reinstalled the motor (stand worked just fine now) ! Pulled the exhaust header and reinstalled come clamps missing from inside the heat cover.Installed the drive shaft and covers. And also started installing the front A frames.
The new shocks got here and 2 are good and 2 are the wrong ones ! Its always the ones I need ! Going to do a mock up with pvc tubing to get the weights at the coners and then order springs.
I will install the rear struts and the maybe plug the motor into the harness and see what works ? Hope things go well ??